3D - ACA 500 X-Tra Cut Compound - 32oz

3D - ACA 500 X-Tra Cut Compound - 32oz

Regular price
$35.00
Sale price
$35.00
Regular price
Sold out
Unit price
per 

 

3D ACA™ 500 X-TRA CUT COMPOUND™ contains ALPHA CERAMIC ALUMINA™ – a cutting-edge abrasive which enables rapid, low-heat leveling of even the most demanding clearcoats and single stage paint. This intricate compound delivers unrivaled paint to ideal condition in the least amount of time. This is a powerful, versatile cutting compound. Designed to remove defects from hard ceramic clear coats without over-lacerating soft clears, its advanced formula contains no solvents, kerosene or crystalline silica. Easy to apply, clean, and use.


HOW-TO USE:

IMPORTANT: 3D ACA 500 cuts fast. Be sure to understand the paint you are working on before starting. This compound was originally developed for working on fresh, custom paint work in body shop situations where the technician knows how much paint is being sprayed onto the panels or entire car body. If you’re a detailer working on customer cars, remember factory paint is thin. Always do a Test Spot and use the least aggressive process to get the job done. Always work on a cool clean surface in the shade.

Body Shops – Using a rotary polisher

Step 1: Prepare the surface by sanding the paint with the sanding paper of your choice.

Step 2: Attach preferred foam or wool cutting pad to backing plate on rotary polisher and set speed setting to low or medium.

Step 3: Apply 4-5 dime sized drops of product onto center of face of buffing pad. Press face of pad against body panel, turn polisher on and spread product over area to be worked, about 2’ by 2’.

Step 4: Move polisher over paint using a slow to medium arm speed. Monitor defect removal as you buff. Once sanding marks or paint defects are removed, stop buffing and remove any excess product using a clean, soft microfiber towel.

Detail Shops/Enthusiasts – Using an orbital polisher

NOTE: 3D ACA 500 X-TRA CUT COMPOUND is formulated for and intended to be used with wool pads on rotary polishers. Best results are obtained using this type of tool and pad. Results may vary when used with orbital polishers and microfiber and foam pads.

Step 1: Prepare the surface by first washing, drying, and removing any above surface bonded contaminants using detailing clay or a clay substitute.

Step 2: Attach preferred foam, microfiber or wool cutting pad to backing plate on orbital polisher and set speed setting to low or medium.

Step 3: Apply 4-5 dime sized drops of product onto center of face of buffing pad. Press face of pad against body panel, turn polisher on and spread product over area to be worked, about 2’ by 2’.

Step 4: Turn polisher to a medium to high speed and begin making overlapping passes. Move polisher over paint using a slow to medium arm speed. Monitor defect removal as you buff. Once paint defects are removed to your satisfaction, stop buffing and remove any excess product using a clean, soft microfiber towel.

Customer Reviews

Based on 1 review Write a review